Explorer 2WD V6-245 4.0L VIN X SFI (1999)
Electronic Brake Control Module: Service and Repair
Removal
1. CAUTION: Prior to removal of the module, it is necessary to upload module configuration information to the New Generation STAR
(NGS) Tester. This information needs to be downloaded into the new module once installed.
Disconnect the battery ground cable.
2. Remove the hydraulic control unit bolts.
3. Disconnect the anti-lock brake control module electrical connectors.
4. Remove the anti-lock brake control module.
1
Remove the bolts.
2
Remove the control module.
Installation
