Explorer 2WD V6-245 4.0L VIN X SFI (1999)
Parking Brake Shoe: Service and Repair
Special Service Tool(s)
Removal
1. NOTE: Make sure the parking brake controls fully released.
Relieve the tension on the parking brake system.
1
Pull the front parking brake cable and conduit.
2
Insert a 4 mm (5/32 inch) drill bit or equivalent retainer.
2. WARNING: The electrical power to the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension
vehicle. This can be accomplished by turning off the air suspension switch located in rear jack storage area. Failure to do so can result in
unexpected inflation or deflation of the air springs, which can result in shifting of the vehicle during these operations.
Raise and support the vehicle.
3. Remove the tire and wheel assembly.