Explorer 2WD V6-245 4.0L VIN X SFI (1999)
7. If required, remove the crankshaft key.
Installation
1. If removed, install the crankshaft key.
2. Using the Vibration Damper and Seal Replacer, install the crankshaft damper.
-
Coat the sealing surfaces of the crankshaft damper with clean engine oil.
-
Coat the crankshaft damper keyway with silicone rubber.
-
Use Silicone Rubber Gasket and Sealant F6AZ-19562-AA or equivalent meeting Ford specification WSE-M4G-323-A6.
-
Install the crankshaft damper.
3. Install a new bolt and the washer.
-
Tighten the bolt in two steps.
1
Tighten to 40-50 Nm (30-37 ft. lbs.).
2
Tighten an additional 80-90°.
4. Install the drive belt.
