Explorer 2WD V6-245 4.0L VIN X SFI (1999)
1. Insert a new wheel stud in the hole in the axle flange, making sure the serrations are aligned with those made by the original wheel stud.
2. Seat new wheel studs in axle flange.
^
Place four flat washers over the outside end of the wheel stud.
^
Thread a standard wheel nut with the flat side against the washers.
^
Tighten the wheel nut until the wheel stud head seats against the back side of the flange.
3. Remove the wheel nut and flat washers.
4. Install the brake disc, rear disc support bracket and the rear disc brake caliper, if so equipped.
5. Install the wheel and tire assembly.
6. Lower the vehicle.
7. Turn the air suspension service switch on, if so equipped.
