Explorer 2WD V6-245 4.0L VIN X SFI (1999)
Spark Plug: Service and Repair
Spark Plug Wire Remover
SPECIAL SERVICE TOOLS
REMOVAL
1. Use the special tool with a twisting motion to pull the spark plug wire off the spark plug.
CAUTION
^
Spark plug wires must be connected properly. Mark the spark plug wires before removing them from the spark plugs.
^
It is important to twist the spark plug wire boots while pulling upward to avoid possible damage to the spark plug wire.
^
Do not use special tool on spark plug wire boots with metal heat shields. Damage to the spark plug wire boots may occur.
2. Remove the LH spark plugs.
NOTE
^
Use compressed air to remove any debris in the spark plug well before removing the spark plugs.
^
If an original spark plug is reused, make sure it is installed in the same cylinder from which it was taken. New spark plugs can be used in any
cylinder.