Explorer 2WD V6-245 4.0L VIN X SFI (1999)
11. Install the hog rings.
12. Unroll the seat backrest trim cover to the bottom row of hog rings.
13. Install the hog rings.
14. If equipped, install the seat backrest trim cover swing rods.
1. Position the seat backrest trim cover and install the swing rods through the sleeves.
2. Install the hog rings.
NOTE: Make sure that the top of the swing rod is positioned beneath the listing wire near the middle row of hog rings.
15. Connect the hook and loop fastener to the seat backrest trim cover.
1. Pull the seat backrest trim cover completely down.
2. Reach up inside the seat backrest and grab the plastic above the hook and loop. Remove enough plastic to expose the hook and loop.
