Explorer 2WD V6-245 4.0L VIN X SFI (1999)
3. Remove the two driver side air bag module retaining bolts.
4. Remove the driver air bag module.
1
Disconnect the driver air bag module electrical connector.
2
Remove the driver air bag module.
INSTALLATION
NOTE:
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and perform the diagnostic
procedure again.
-
Make sure to tighten the retaining bolts to specification.
1. Follow the removal procedure in reverse order.
2. Prove out the air bag system.
