Explorer 2WD V6-245 4.0L VIN X SFI (1999)
1. Use Safety Belt Bolt Bit to install the front seat belt retractor.
2. Install the B-pillar trim panel.
3. Check the restraint system for proper operation.
C-Pillar
Safety Belt Bolt Bit
Special Tool(s)
REMOVAL
WARNING: All seat belt assemblies including retractors, buckles, front seat belt buckle support assemblies (slide bar), shoulder belt height
adjusters (if so equipped) child safety seat tether attachments and attaching hardware should be inspected after any collision. All belt
assemblies should be replaced unless a qualified technician finds the assemblies show no damage and operate properly. Belt assemblies not in
use during a collision should also be inspected and replaced if either damage or improper operation is noted.
1. Remove the quarter trim panel.
2. Remove the seat belt retractor.
1
Use Safety Belt Bolt Bit to remove the bolt.
2
Remove the seat belt retractor.
INSTALLATION