Explorer 2WD V6-245 4.0L VIN X SFI (1999)
Impact Sensor: Service and Repair
Front External Crash Sensor
REMOVAL
WARNING:
-
Vehicle sensor orientation is critical for proper system operation. If a vehicle equipped with an air bag Supplemental Restraint System
(SRS) is involved in a collision, inspect the sensor mounting bracket and wiring pigtail for deformation. Replace and properly position the
sensor or an, other damaged supplemental restraint system (SRS) components whether or not the air bag is deployed.
-
To avoid accidental deployment and possible personal injury, the backup power supply must be depleted before repairing or replacing
any front or side air bag supplemental restraint system (SRS) components and before servicing, replacing, adjusting or striking
components near the front or side air bag sensors, such as doors, instrument panel, console, door latches, strikers, seats and hood latches.
The side air bag sensors are located at or near the base of the B-pillar.
To deplete the backup power supply energy, disconnect the battery ground cable and wait at least one minute. Be sure to disconnect auxiliary
batteries and power supplies (if equipped).
NOTE: A repair is made by installing a new part only. If the new part does not correct the condition, install the original part and perform the
diagnostic procedure again.
1. Disconnect the battery ground cable and wait at least one minute.
2. Remove the radiator grill and radiator opening cover.
3. Remove the air bag sensor.
1
Disconnect the air bag sensor electrical connector.
2
Remove the three screws.
3
Remove the air bag sensor.
INSTALLATION
WARNING: Vehicle sensor orientation is critical for proper system operation. If a vehicle equipped with an air bag supplemental restraint
system (SRS) is involved in a collision, inspect the sensor mounting bracket and wiring pigtail for deformation. Replace and properly position
the sensor or any other damaged supplemental restraint system (SRS) components whether or not the air bag is deployed.
CAUTION: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage can result.
NOTE: A repair is made by installing a new part only. If the new part does not correct the condition, install the original part and perform the
diagnostic procedure again.
1. Follow the removal procedure in reverse order.
