Explorer 2WD V6-245 4.0L VIN X SFI (1999)
Preload the torsion bar.
1. Install the Torsion Bar Tool and the adapters.
2. Tighten the Torsion Bar Tool until the new adjustment bolt and nut can be installed.
3. Turn the adjustment bolt until the preliminary adjustment measurement (recorded length of the old adjustment bolt) is reached.
4. Install the torsion bar cover plate.
1. Position the torsion bar cover plate.
2. Install the torsion bar cover plate bolts.
5. NOTE: If equipped with air suspension, reactivate the system by turning on the air suspension switch.
Lower the vehicle.
6. Adjust the ride height.
7. Check the alignment.
