Explorer 2WD V6-245 4.0L VIN X SFI (1999)
6. Disconnect the solenoid electrical connectors.
1
Disconnect shift solenoids SSB and SSD electrical connectors.
2
Disconnect the Torque Converter Clutch (TCC) solenoid electrical connector.
3
Disconnect the Electronic Pressure Control (EPC) solenoid electrical connector.
7. CAUTION: The TCC solenoid and converter modulator valve may pop out of its bore. This may damage the solenoid or converter
modulator valve.
Remove the EPC, SSB, and SSD solenoids.
1
Remove the wire harness.
2
Remove the solenoid clamp screws.
3
Remove the solenoid clamp.
4
Remove the EPC, SSB, and SSD solenoids.
8. CAUTION: Do not pry on the other wires or damage to the connector case surface may result.
Disconnect the Turbine Shaft Speed (TSS) sensor electrical connector from the transmission case (16 pin) electrical connector.
1
Disconnect the TSS sensor electrical connector.
2
Remove the TSS sensor wire locator.
