Explorer 2WD V6-245 4.0L VIN X SFI (1999)
4. Use Extension Housing Seal Replacer to install the extension housing seal.
5. NOTE: Inspect the driveshaft slip-yoke for wear and damage. Replace if required.
Align the drive shaft with the marks made during removal to ensure correct balance.
6. Install the rear driveshaft bolts.
7. Lower the vehicle.
8. Fill the transmission to the proper fluid level and check for proper transmission operation.
-
Use MERCON V Automatic Transmission Fluid XT-5-QM or equivalent meeting MERCON V specification.
