Explorer 2WD V6-245 4.0L VIN X SFI (1999)
13. Use the Seal Remover to remove the extension housing seal.
14. Remove the extension housing.
1
Remove the bolts.
2
Remove the extension housing.
Installation
1. NOTE: The extension housing must be installed within four minutes after applying silicone.
Apply a small bead of Silicone Rubber D6AZ-19562-AA or equivalent meeting Ford specification ESB-M4G92-A to the surface of the case.
2. Install the extension housing.
1
Position the extension housing.
2
Install the bolts.
3. Use Extension Housing Seal Replacer to install the extension housing seal.
4. Raise and position the transmission.
