Explorer 2WD V6-245 4.0L VIN X SFI (1999)
5. Install the (RH) transmission mount bolt.
1
Position the exhaust bracket.
2
Install the bolt.
6. Install the crossmember.
1
Position the crossmember.
2
Install the six bolts and nuts (three each side).
7. Remove the Hi-Lift Jack.
8. Install the nuts.
9. NOTE: To maintain initial driveshaft balance, align marks on the rear driveshaft centering socket yoke and rear axle universal joint flange made
during removal.
Install the rear driveshaft.
1
Position the rear driveshaft.
2
Install the four bolts.
