Explorer 2WD V6-4.0L (2009)
7. Install the backrest frame to the inboard and outboard latches in the following sequence.
1. Position the backrest frame to the inboard and outboard latches and hand-start the 2 inboard and 2 outboard latch-to-backrest frame bolts.
2. Hand-start the outboard upper pivot latch bolt.
3. Install the 2 inboard latch-to-backrest frame bolts.
-
Tighten to 40 Nm (30 lb-ft).
4. Install the 2 outboard latch-to-backrest frame bolts.
-
Tighten to 40 Nm (30 lb-ft).
5. Install the outboard upper pivot latch bolt.
-
Tighten to 40 Nm (30 lb-ft).
8. NOTE: The cable is to move freely after assembly.
Install the backrest support panel screws to the backrest frame.
-
Attach the latch release cable to the backrest support panel.
9. Route the latch release cable through the inboard latch holder.
All vehicles
10. Position the latch release cable in front of the spring.
11. Roll the backrest trim cover down.
-
For Sport Trac, route the safety belt through the backrest trim cover.
-
Attach the backrest trim cover to backrest foam pad hook-and-loop strips.
