Explorer 2WD V6-4.0L (2009)
Engine Block Heater: Service and Repair
Block Heater
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Drain the cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding See: Cooling System/Service and
Repair/Procedures/Cooling System Draining, Filling and Bleeding.
3. Disconnect the block heater power cable.
4. NOTE: Do not loosen the block heater retaining screw more than necessary for removal.
Loosen the screw and remove the block heater.
-
To install, tighten to 4 Nm (35 lb-in).
5. Clean and inspect the engine block mating surface. Lubricate the block heater seal and the cylinder block hole with clean engine coolant.
6. NOTICE: Make sure the power cable is routed and secured away from rotating or hot components or the cable may be damaged.
To install, reverse the removal procedure.