Explorer 2WD V6-4.0L (2009)
7. Remove the bolt and install the Engine Lifting Bracket.
-
Tighten to 42 Nm (31 lb-ft).
8. Install the Engine Support Bar and the 2 Adapters for 303-290A.
9. Remove the LH engine support insulator through bolt.
-
To install, tighten to 103 Nm (76 lb-ft).
10. Remove the 5 pushpins and the RH inner fender splash shield.
11. Remove the 3 RH engine support insulator nuts.
-
To install, tighten to 90 Nm (66 lb-ft).
12. Raise the engine approximately 60 mm (2.36 in).
13. Remove the RH engine support insulator.
All-Wheel Drive (AWD) vehicles
14. Remove the 4 bolts and the 2 stabilizer bar brackets. Allow the stabilizer bar to hang freely.
-
To install, tighten to 55 Nm (41 lb-ft).
15. WARNING: Secure the assembly to the jack. Avoid any obstructions while lowering and raising the jack. Contact with obstructions may
cause the assembly to fall off the jack, which may result in serious personal injury.
Support the axle housing with a suitable jack.
16. Disconnect the axle housing vent hose from the axle housing vent tube.
17. NOTICE: Any time bolts, washers, spacers or nuts are loosened in the axle housing for any reason, install new components to prevent
damage.
