Explorer 2WD V6-4.0L (2009)
Rotate the panel door vacuum control motor until it clears the retaining arm and remove the panel door vacuum control motor.
8. To install, reverse the removal procedure.
Auxiliary Temperature Blend Door Actuator
Auxiliary Temperature Blend Door Actuator
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the LH quarter trim panel.
3. Remove the 2 auxiliary line floorpan bracket nuts.
-
To install, tighten to 8 Nm (71 lb-in).
4. Remove the 2 auxiliary heater core and evaporator core housing bolts.
-
To install, tighten to 6 Nm (53 lb-in).
5. Remove auxiliary heater core and evaporator core housing nut.
-
To install, tighten to 6 Nm (53 lb-in).
6. Disconnect the auxiliary harness electrical connector.