Explorer 2WD V6-4.0L (2009)
6. Remove the 2 rear auxiliary evaporator line front fitting nuts and disconnect the fittings.
-
Discard the O-ring seals.
-
To install, tighten to 8 Nm (71 lb-in).
7. Remove the 2 rear auxiliary evaporator line rear fitting nuts and disconnect the fittings.
-
Discard the O-ring seals.
-
To install, tighten to 8 Nm (71 lb-in).
8. Remove the auxiliary line bracket nut.
-
To install, tighten to 6 Nm (53 lb-in).
9. Remove the 2 auxiliary line brackets.
10. Remove the rear auxiliary evaporator outlet line.
11. Remove the rear auxiliary evaporator inlet line.
-
Discard the Thermostatic Expansion Valve (TXV) filter.
12. To install, reverse the removal procedure.
-
Install new O-ring seals.
-
Install a new TXV filter.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil.
13. Evacuate, leak test and charge the refrigerant system.
