Explorer 2WD V6-4.0L (2009)
test results.
-
Disconnect: APIM C3342.
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
CONNECT the APIM. Go To Pinpoint Test P. See: Pinpoint Test P: The Accessory Protocol Interface Module (APIM) Does Not Respond To The
Scan Tool
No
CONNECT the APIM. Go To Pinpoint Test K. See: Pinpoint Test K: The Satellite Digital Audio Receiver System (SDARS) Module Does Not
Respond To The Scan Tool
-------------------------------------------------
R16 VERIFY VEHICLE EQUIPMENT - PAM
-
Inspect the vehicle for a PAM.
-
Is the vehicle equipped with a PAM?
Yes
GO to R17.
No
GO to R18.
-------------------------------------------------
R17 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE PAM DISABLED
-
Disconnect: SJB Fuse 18 (10A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuse. Go To Pinpoint Test O. See: Pinpoint Test O: The Parking Aid Module (PAM) Does Not Respond To The Scan Tool
No
INSTALL the removed fuse. GO to R18.
-------------------------------------------------
R18 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE IC DISABLED
NOTE: When re-running the network test, the network test application must be first closed or the screen display will revert back to the prior run network
test results.
-
Disconnect: SJB Fuse 8 (15A) and 24 (10A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuses. Go To Pinpoint Test G. See: Pinpoint Test G: The Instrument Cluster (IC) Does Not Respond To The Scan Tool
No
INSTALL the removed fuses. An intermittent fault is not present. Go To Pinpoint Test Q. See: Pinpoint Test Q: No Medium Speed Controller Area
Network (MS-CAN) Communication, All Modules Are Not Responding
