Explorer 2WD V6-4.0L (2009)
Disassembly and Assembly
1. Remove the shock absorber and spring assembly. For additional information, refer to Shock Absorber and Spring Assembly See: Removal and
Replacement/Rear Suspension.
2. Using a suitable spring compressor, compress the spring until the tension is released from the shock absorber.
3. NOTICE: When installing the shock rod nut, make sure the shock rod and bushing are centered in the upper mount before tightening the
nut or damage to the shock bushing may occur.
NOTE: Use the hex-holding feature to prevent the shock absorber rod from turning while removing and installing the nut.
Remove and discard the shock absorber rod nut.
-
To install, tighten the new nut to 65 Nm (48 lb-ft).
