Explorer 2WD V6-4.0L (2009)
Wheel Bearing: Service and Repair
Rear Suspension
Wheel Bearing and Wheel Hub
Removal and Installation
NOTICE: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure may result
in major service expense. New parts must be installed with the same part numbers or equivalent part, if replacement is necessary. Do not use a
replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct
retention of these parts.
1. Remove the wheel knuckle. For additional information, refer to Wheel Knuckle See: Rear Knuckle/Service and Repair.
2. Remove the 3 brake disc shield bolts.
-
To install, tighten to 8 Nm (71 lb-in).
3. Using the Bearing Puller and a suitable press, remove the wheel hub.
