Explorer 2WD V6-4.0L (2009)
Installation
1. NOTE: Make sure the extension housing seal is correctly installed onto the Transmission Extension Housing Oil Seal Installer and the garter
spring is in the correct position.
Using the Transmission Extension Housing Oil Seal Installer, install the extension housing seal.
2. Install the driveshaft.
3. Carry out the transmission fluid level check. For additional information, refer to Transmission Fluid Level Check See: Service and
Repair/Procedures/5R55S/Transmission Fluid Level Check.
Extension Housing Gasket
Extension Housing Gasket - Rear Wheel Drive (RWD)
Removal
1. With the vehicle in NEUTRAL, position it on a hoist.