Explorer 2WD V6-4.0L (2009)
2. NOTE: Verify the park lever actuating rod is correctly seated into the case parking rod guide cup.
Install the extension housing and the extension housing screws.
-
Tighten to 30 Nm (22 lb-ft).
3. Install the transmission support insulator and lower the transmission onto the transmission support insulator.
4. Install the transmission support insulator-to-extension housing screws.
-
Tighten to 90 Nm (66 lb-ft).
5. Install the transmission support insulator-to-crossmember nuts.
-
Tighten to 90 Nm (66 lb-ft).
6. Install the driveshaft.
7. Carry out the transmission fluid level check. For additional information, refer to Transmission Fluid Level Check See: Service and
Repair/Procedures/5R55S/Transmission Fluid Level Check.
