Explorer 2WD V6-4.0L (2009)
9. Remove the transmission cooler tubes from the vehicle.
Installation
1. Install the transmission cooler tubes into the vehicle.
2. Install the transmission fluid cooler tube bracket onto the stud.
3. Verify the case fitting torque.
-
Tighten to 56 Nm (41 lb-ft).
4. NOTICE: To prevent cross threading, all transmission fluid cooler tube nuts must be hand-started before being tightened to specification.
Using a backup wrench to hold the case fittings securely, install the transmission fluid cooler tubes.
-
Tighten to 40 Nm (30 lb-ft).
