Explorer 2WD V6-4.0L (2009)
4. NOTE: If new pinion flange bolts are not available and the originals are not damaged, they can be reused if the threads are coated with threadlock
and sealer.
Remove and discard the 4 driveshaft pinion flange bolts.
-
To install, tighten the new bolts to 112 Nm (83 lb-ft).
5. NOTE: The driveshaft flange yoke fits tightly on the pinion flange pilot. Never hammer on the driveshaft, or any of its components, to disconnect
the driveshaft flange from the pinion flange.
Using a suitable tool, pry only in the area shown to separate the driveshaft flange yoke from the pinion flange and remove the driveshaft from the
extension housing.
6. NOTE: The driveshaft flanges fit tightly on the pinion flange pilot. To make sure that the driveshaft flange seats squarely on the pinion flange,
tighten the driveshaft flange bolts evenly in a cross pattern.
NOTE: If new driveshaft flange bolts are not available, coat the threads of the original driveshaft flange bolts with threadlock and sealer.
To install, reverse the removal procedure.
Driveshaft - Rear, Two-Piece
Driveshaft - Rear, Two-Piece, Rear Wheel Drive (RWD)
