Explorer 2WD V6-4.0L (2009)
-
Remove and discard the hub nut.
13. NOTICE: The wheel hub nut contains a one-time locking chemical that is activated by the heat created when it is tightened. Install and
tighten the new wheel hub nut to specification within 5 minutes of starting it on the threads. Always install a new wheel hub nut after
loosening or when not tightened within the specified time or damage to the components can occur.
NOTE: Apply the brake to keep the halfshaft from rotating.
Install a new hub nut.
-
Tighten to 350 Nm (258 lb-ft).
14. NOTE: Always install a new differential stub shaft seal whenever the halfshaft is removed.
NOTE: Make sure the halfshaft is completely seated in the differential side gear by pushing the halfshaft into the rear axle assembly until an
audible click is heard or a leak may occur from the axle assembly.
NOTE: Apply the brake to keep the halfshaft from rotating.
To install, reverse the removal procedure.
