Explorer 2WD V6-4.0L (2009)
Windshield Washer Reservoir: Service and Repair
Washer Reservoir
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the Air Cleaner (ACL) assembly.
3. Remove the RH front fender splash shield.
4. Disconnect the windshield washer pump electrical connector.
5. Disconnect the windshield washer solvent level electrical connector.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice.
For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result
in serious personal injury.
NOTE: If necessary, drain the windshield washer reservoir after removal.
6. Disconnect the windshield washer reservoir hoses.
7. Remove the top bolt.
-
To install, tighten to 5 Nm (44 lb-in).
