Explorer 2WD V6-4.0L VIN E (2001)
24. Remove the side air bag wire harness tie strap retainer.
25. Position the side air bag module aside, through the seat back cushion opening.
^
Remove the retaining nuts.
NOTE: If installing a new side air bag module, use new retaining nuts. If the same side air bag module is to be reused, then reuse the side air bag
module retaining nuts.
26. Remove the side air bag module.
1
Slide the side air bag module electrical connector locking clip to disengage it.
2
Release the connector tabs by pushing in on them, then disconnect the side air bag module electrical connector.
3
Remove the side air bag module.
INSTALLATION
WARNING:
