Explorer 2WD V6-4.0L VIN E (2001)
Remove the nut and bolt and separate the upper ball joint from the wheel knuckle.
^
Discard the nut.
6. CAUTION: Do not use a hammer to separate the outboard CV joint from the hub. Damage to the threads and internal CV joint components may
result.
Using the special tool, press the outboard CV joint until it is loose from the hub.
7. Remove the nut and bolt and the wheel knuckle, hub and bearing as an assembly.
^
Discard the nut.
8. If necessary, remove the hub and bearing.
9. To install. reverse the removal procedure.