Explorer 2WD V6-4.0L VIN E (2001)
Extension Housing: Service and Repair
Extension Housing Gasket - 4X2
Removal
1. Disconnect the battery ground cable.
2. Raise and support the vehicle.
3. Note: To maintain initial driveshaft balance, mark the rear driveshaft yoke and axle flange so they may be installed in their original alignment.
Mark the rear driveshaft.
4. Remove the rear driveshaft.
1. Remove the bolts.
2. Remove the rear driveshaft.
5. Remove the nuts.
6. Raise and support the transmission.
