Explorer 2WD V6-4.0L VIN K (2007)
2. Using an appropriate tool, push in the hole of each head restraint guide while lifting up and remove the head restraint.
3. Remove the safety belt anchor bolt.
-
To install, tighten to 75 Nm (55 lb-ft).
4. Pull out at the bottom and remove the safety belt guide cover.
5. Release the backrest trim cover J-clip.
6. Remove all the staples in the backrest support panel.
7. CAUTION: Use care when separating the seat upholstery from the hook-and-loop strip, or the hook-and-loop strip can be torn from the
seat backrest foam pad.
Separate the hook-and-loop fasteners, invert the backrest trim cover and remove the hog rings.
8. NOTE:
-
The inboard and outboard head restraint sleeves are not interchangeable.
-
The head restraint sleeves incorporate an alignment tab that must face forward when installed.
Squeeze together the tip of the head restraint sleeve and pull the sleeve out of the frame tube.
9. Separate the hook-and-loop fasteners. Remove the backrest trim cover.
-
Feed the safety belt out through the backrest trim cover.
10. To install, reverse the removal procedure.
Seat Cushion Cover - Second Row, 40 Percent, Bench
SEAT CUSHION COVER - SECOND ROW, 40 PERCENT, BENCH
