Explorer 2WD V6-4.0L VIN K (2007)
Air Door Actuator / Motor: Service and Repair
Temperature Blend Door Actuator - LH
TEMPERATURE BLEND DOOR ACTUATOR - LH
Removal and Installation
1. Remove the LH floor console finish panel.
2. Position the in-vehicle temperature sensor aspirator hose away from the LH temperature blend door actuator.
3. Remove the 3 LH temperature blend door actuator screws.
4. Disconnect the LH temperature blend door actuator electrical connector.
5. Remove the LH temperature blend door actuator.
6. To install, reverse the removal procedure.