Explorer 2WD V6-4.0L VIN K (2007)
4. If the evaporator core orifice is intact, engage the special tool. Hold the T-handle stationary while rotating the tool body to remove the evaporator
core orifice.
5. If the evaporator core orifice is broken, screw the end of the special tool into the broken orifice. Hold the T-handle stationary while rotating the
tool body to remove the evaporator core orifice.
Installation
1. Lubricate the evaporator core orifice O-rings with clean PAG oil and install the evaporator core orifice using the special tool.
2. Install a new O-ring seal and connect the evaporator core orifice access fitting.
-
To install, tighten to 24 Nm (18 lb-ft).
3. Lubricate the refrigerant system with the correct amount of clean PAG oil.
4. Evacuate, leak test and charge the refrigerant system.
