Explorer 2WD V6-4.0L VIN K (2007)
Fluid Filter - A/T: Service and Repair
Transmission Filter - In Line
Transmission Filter - In Line
Special Tool(s)
Material
NOTE: Use these guidelines for installing the transmission fluid in-line filter:
^
If the transmission was overhauled and the vehicle was equipped with an in-line fluid filter, install a new in-line fluid filter.
^
If the transmission was overhauled and the vehicle was not equipped with an in-line fluid filter, install a new in-line fluid filter kit.
^
If the transmission is being installed for a non-internal repair, do not install an in-line filter or filter kit.
^
If installing a Ford-authorized remanufactured transmission, install the in-line transmission fluid filter that is supplied.
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Remove the secondary latch from the fluid cooler connector.
3. Using the special tool, disconnect the fluid cooler connector.
4. Remove the section of the steel tube at the second flare.