Explorer 2WD V6-4.0L VIN K (2007)
2. Remove the fuel tank shield from the fuel tank.
3. Disconnect the fuel tank pressure sensor electrical connector.
4. Disconnect the 3 fuel tank pressure sensor and tube assembly quick connect couplings from the fuel pump module and the vapor vent valves.
5. Remove the fuel tank pressure sensor and tube assembly.
6. To install, reverse the removal procedure.
7. Leak test the evaporative emission system. See: Powertrain Management/Emission Control Systems/Evaporative Emissions System/Testing and
Inspection/Evaporative Emission System Leak Test
8. Carry out the evaporative emission repair verification drive cycle. See: Powertrain Management/Emission Control Systems/Evaporative
Emissions System/Testing and Inspection/Evaporative Emission Repair Verification Drive Cycle
