Explorer 2WD V6-4.0L VIN K (2007)
12. If the flow is not liberal, disconnect the hose from the cooler return line and connect the hose to the cooler inlet (lower fitting) on the transmission
case. Reconnect the cooler return line to the case (upper fitting).
^
Tighten to 40 Nm (30 ft. lbs.)
13. Repeat Steps 8 through 11. If flow is now approximately 208 ml (7 oz) in 15 seconds, the cooler lines and auxiliary cooler must be cleaned.
Carry out this entire test after the backflushing and cleaning procedure. If, after carrying out the backflushing and cleaning procedure, the flow is
still not adequate, new cooler lines and/or an auxiliary cooler must be installed. If the flow from the case is still not adequate after the installation
of new cooler lines and/or an auxiliary cooler (208 ml [7 oz] in 15 seconds), the pump and/or torque converter may be at fault. Carry out the
appropriate procedures for diagnosis and repair.
