Explorer 2WD V6-4.0L VIN K (2007)
4. Tighten the screws in the sequence shown.
^
Tighten to 10 Nm (89 inch lbs.)
5. Install the manual control valve detent spring.
^
Tighten to 10 Nm (89 inch lbs.)
6. Install the reverse servo. Tighten the screws in 2 stages, in the sequence shown.
^
Stage 1: Tighten to 5 Nm (44 inch lbs.)
^
Stage 2: Tighten to 11 Nm (8 ft. lbs.)
