Explorer 2WD V6-4.0L VIN K Flex Fuel (2002)
7. Remove the upper and lower B-pillar trim panels to access the hinge fasteners.
8. Mark the position of the rear door hinges as a reference point.
9. Position aside the front door weatherstrip to access the rear hinge nuts.
10. Loosen, but do not remove, the rear door hinge to body bolts and nut just enough to permit movement of the door.
11. Adjust the rear door alignment to specification.
12. Tighten the rear door hinge to body bolts and nut.
13. Install the door striker and adjust as necessary.