Explorer 2WD V6-4.0L VIN K Flex Fuel (2002)
6. Remove the heated seat module.
1. Disconnect the heated seat module electrical connector.
2. Insert a flat-bladed screwdriver into the locking tab access slot and release the module from the bracket.
3. Remove the module.
Installation
All vehicles
1. Install the heated seat module.
1. Install the heated seat module in the mounting bracket. Verify that the module is locked into the mounting bracket.
2. Connect the heated seat module electrical connector.
Vehicles built up to 03/2002, with memory seat
2. Slide in the memory module. Install the four screws in the memory module bracket.
3. Connect the two inboard side memory module electrical connectors.
All vehicles
4. Install the seat in the vehicle.
5. Repower the SRS.
