Explorer 2WD V6-4.0L VIN K Flex Fuel (2002)
5. Remove the screws.
6. Remove the screw and detach the LH temperature blend door actuator from the heater core and evaporator core housing assembly.
7. Disconnect the electrical connector and remove the temperature blend door actuator.
INSTALLATION
1. To install, reverse the removal procedure.
Temperature Blend Door Actuator - RH, DATC
REMOVAL
1. Deactivate the Supplemental Restraints System (SRS).
2. Remove the floor console unit.
3. Remove the instrument panel center support brackets.
