Explorer 2WD V6-4.0L VIN K Flex Fuel (2002)
7. Apply a maximum of 206.85 kPa (30 psi) to the open end of the vacuum/pressure hose from the special tool. Fluid will immediately start flowing
out of the special tool into the transmission fluid pan.
8. Add two or three quarts of transmission fluid into the fluid pan. Stop the process by releasing the air pressure and removing the air nozzle from the
end of the hose.
9. Install a new torque converter drain plug to prevent any leakage.
10. Install the converter housing access plug.
Note: Engine idle speed is approximately 650 rpm.
11. Start and run the engine until the transmission fluid temperature is between 27 ° C - 49 ° C (80 ° F - 120 ° F).
12. Inspect the fluid level in the special tool. If the fluid drains back into the canister, the transmission is full. If no fluid drains back, more fluid will
need to be added. Repeat steps 11 and 12.
13. Once the transmission is full, place a hand vacuum pump on the open end of the hose of the special tool and apply vacuum to the system. This will
pull any extra fluid trapped in the system and direct it into the container.