Explorer 2WD V6-4.0L VIN K Flex Fuel (2002)
Note: Left side of case is shown.
1. Using the scan tool (WDS), monitor the transmission fluid temperature (TFT) using PID: TFT.
2. Start the vehicle.
Note: Engine idle speed is approximately 650 rpm.
3. While proceeding with this procedure, run the engine until the transmission fluid temperature is between 27 ° C - 49 ° C (80 ° F - 120 ° F ).
4. Move the range selector lever slowly through each gear, stopping in each position and allowing the transmission to engage.
5. Place the range selector lever in the PARK position.
6. With the engine running and the vehicle set as close to level as possible, position it on a hoist. For additional information.
7. Hold the larger drain plug with a wrench and remove the small (center) fluid level indicating plug using a 3/16 inch Allen key.
8. Allow the fluid to drain. Wait approximately one minute. When the fluid comes out as a thin stream or a drip, the fluid is at the correct level.
9. If no fluid comes out of the hole, fluid will need to be added to continue with this procedure.
