Explorer 2WD V6-4.0L VIN K Flex Fuel (2002)
-
Before using the R-134a fluorescent dye injector for the first time, refer to the equipment manufacturers instructions on evacuation of
non-condensable gasses from the hoses.
-
Refrigerant system pressure should be between 413-551 kPa (60-80 psi) at 24°C.
1. Verify that the valves on the special tool are closed.
2. Fill the special tool reservoir with 7 ml (0.25 oz) of fluorescent dye.
3. Install the special tool between the high-pressure and low-pressure service gauge port valves.
4. Start the engine.
CAUTION: Make sure all tools and hoses are clear of the engine cooling fan and drive belt before starting the engine.
5. Open the high-pressure service valve.
6. Open the special tool valves and inject the fluorescent dye into the refrigerant system.