Explorer 2WD V6-4.0L VIN K Flex Fuel (2002)
Electronic Brake Control Module: Service and Repair
Anti-Lock Brake System (ABS) Module
Removal and Installation
All vehicles
1. Disconnect the battery ground cable.
Vehicles built before 3/2002
2. Disconnect the electrical connectors.
3. Remove the three bolts.
4. With the vehicle in NEUTRAL, position the vehicle on a hoist.
5. Remove the three nuts from the lower bracket and position the anti-lock control module and HCU aside.
Vehicles built after 3/2002
6. Remove the anti-lock brake control module screws and remove the anti-lock brake control module.
