Explorer 2WD V6-4.0L VIN K Flex Fuel (2002)
Air Bag Control Module: Service and Repair
Removal and Installation
RESTRAINTS CONTROL MODULE (RCM)
Removal
WARNING:
-
Do not handle, move or change the original horizontal mounting position of the restraints control module (RCM) while the RCM is
connected and the ignition switch is ON. Failure to follow these instructions may result in the inadvertent deployment of the safety
canopy and risk of personal injury.
-
The restraints control module (RCM) orientation is critical for proper air bag supplemental restraint system (SRS) operation. If a vehicle
equipped with an SRS system has been involved in a collision in which the center tunnel area has been damaged, inspect the mounting
and bracket for deformation. If damaged, the RCM must be replaced whether or not the air bags have deployed. In addition, make sure
the area of the RCM mounting is restored to its original condition.
-
Vehicle sensor orientation is critical for proper system operation. If a vehicle equipped with an air bag supplemental restraint system
(SRS) is involved in a collision, inspect the sensor mounting bracket and wiring pigtail for deformation. Replace and properly position the
sensor or any other damaged supplemental restraint system (SRS) components whether or not the air bag is deployed.
-
Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module.
This will reduce the risk of injury in the event of an accidental deployment.
-
To reduce the risk of personal injury, do not use any memory saver devices.
CAUTION: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage can result.
NOTE:
-
The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate
a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
When installing a new restraints control module (RCM), always make sure the correct RCM is being installed. If an incorrect RCM is installed,
erroneous DTCs will result.
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and perform the diagnostic
procedure again.
All vehicles
1. Depower the system.
2. Remove the floor console.
Vehicles built up to 03/2002
3. Remove the RCM.
1. Slide and disengage the RCM electrical connector locking clips.
2. Push down, releasing the electrical connector and disconnect the RCM electrical connectors.
3. Remove the nuts.
4. Remove the RCM.
Vehicles built 03/2002 onward
