Explorer 2WD V6-4.0L VIN K Flex Fuel (2002)
Side Impact Sensor - First Row, B-Pillar
SIDE IMPACT SENSOR - FIRST ROW, B-PILLAR
Removal
WARNING:
-
Vehicle sensor orientation is critical for correct system operation. If a vehicle equipped with an air bag supplemental restraint system
(SRS) is involved in a collision, inspect the sensor mounting bracket and wiring pigtail for deformation. Replace and correctly position
the sensor or any other damaged supplemental restraint system (SRS) components whether or not the air bag is deployed.
-
Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module.
This will reduce the risk of injury in the event of an accidental deployment.
-
To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
-
The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate
a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and perform the diagnostic
procedure again.
1. Depower the system.
2. Remove the B-pillar trim panel.
3. Remove the side impact sensor.
1. Remove the bolt.
2. Disconnect the electrical connector.
3. Remove the side impact sensor.
Installation
1. Make sure the bolt, washer and clip are in place on the side impact sensor before installing it to the vehicle.
