Explorer 2WD V6-4.0L VIN K Flex Fuel (2002)
Power Steering Bleeding: Service and Repair
Power Steering System Purging
Special Tools
Special tool(s)
CAUTION: If the air is not purged from the power steeling system correctly, premature power steering pump failure can result. The condition can
occur on pre-delivery vehicles with evidence of aerated fluid or on vehicles that have had steering component repairs.
1. NOTE: A whine heard from the power steering pump can be caused by air in the system. The power steering purge procedure must be performed
prior to any component repair for which power steering noise complaints are accompanied by evidence of aerated fluid.
Remove the reservoir cap. Check the fluid.
^
Use MERCON (R) Multi-Purpose (ATF) Transmission Fluid XT-2-QDX or MERCON (R) equivalent.
2. Tightly insert the stopper of the vacuum pump into the reservoir.
3. Start the vehicle.
4. Apply maximum vacuum and maintain it for a minimum of three minutes with the engine speed set at idle.
5. Release the vacuum and remove the vacuum pump.
6. CAUTION: Do not overfill the power steering pump reservoir.
