Explorer 2WD V6-4.0L VIN K Flex Fuel (2002)
18. Attach the restraint system diagnostic tool to the vehicle harness side of the passenger air bag module electrical connector.
Vehicles without side air curtains or safety canopies
19. CAUTION: Do not deactivate the side air curtain/safety canopy module circuit by removing the side air curtain/safety canopy bridge
resistor from the side air curtain/safety canopy electrical connector.
If the side air curtain/safety canopy bridge resistor is removed, an open circuit fault will be generated by the restraints control module (RCM).
If a restraint system diagnostic tool is installed at the side air curtain/safety canopy electrical connector, a low resistance fault will be generated by
the RCM.
Vehicles with side air curtains
NOTE: Once the weatherstrip is lowered, if retaining clips are present in the door jamb at the C-pillar pinch weld, the vehicle will be equipped with
side air curtains.
20. Lower the rear RH door opening weatherstrip.
21. Remove the RH side C-pillar trim panel clips.
