Explorer 2WD V6-4.0L VIN K Flex Fuel (2002)
Suspension Strut / Shock Absorber: Service and Repair
Rear
Solid Rear Axle
Special Service Tool(s)
Removal
WARNING: The electrical power to the air suspension system must be shut off prior to hoisting, jacking or towing of an air suspension
vehicle. This can be accomplished by turning off the air suspension switch located in the rear jack storage area. Failure to do so may result in
unexpected inflation or deflation of the air springs which may result in shifting of the vehicle during these operations.
WARNING: The low pressure gas shock absorbers are charged with nitrogen gas 930 kPa (135 psi). Do not attempt to open, puncture, or
apply heat to the shock absorbers.
1. Connect scan tool to the Data Link Connector (DLC).
2. Select the RIDE CONTROL OUTPUT screen and turn on the following solenoids to vent the entire system of air and to lower the vehicle to its
lowest attainable height:
^
REAR FILL (rear fill solenoid).
^
GATEVALVE(gate solenoid[s]).
^
VENT (vent solenoid).
3. Raise and support the vehicle.
4. Remove the spare tire.
5. Use Hi-Lift Transmission Jack to support the rear axle.
